Bambu H2C Instructions

For more in-depth instructions, visit the following Bernette quick start guide.

Preparing your piece to serge

  1. Serging can be used to prepare individually cut pieces or to create a clean edge when sewing two pieces of fabric together.
  2. Never serge over pins; it will damage both the machine and the pins.
  3. Leave extra seam allowance on the edges of your piece because the serger will trim the edges as you sew.

Sewing with the Serger

  1. Lift the foot pedal using the lever on the right of the machine.
  2. Line up your piece with the edge of the plate on the machine.
  3. Lower the foot pedal.
  4. Gently apply pressure to the foot pedal to serger along the entire edge of your fabric. The machine will cut off excess fabric with the blade.
  5. When you get to the end, let the serger chain off for a few inches and trim with scissors.
  6. Continue this process with all the edges for seams you would like to serge.
close and location of power on and off button.

Switching the Machine and Sewing Light On/Off

  • Set the power switch to I ON
    • The machine and the sewing light are switched on.
  • Set the power switch to 0 OFF
    • The machine and the sewing light are switched off, whereby the sewing light may still glow a little.